Improving fried burger quality and modulating acrylamide formation by active coating containing Rosa canina L. extract nanoemulsions.

During the frying of foods, undesirable reactions such as protein denaturation, acrylamide formation, and so on occur in the product, which has confirmed carcinogenic effects. The use of antioxidants has been proposed as an effective solution to reduce the formation of these compounds during the process. The current study aimed to assess the impact of an edible coating holding within chia seed gum (CSG) and Rosa canina L. extract (RCE) nanoemulsions on the physicochemical properties, oil uptake, acrylamide formation, 5-hydroxymethyl-2-furfural (HMF) content, and sensory characteristics of beef-turkey burgers. The RCE-loaded nanoemulsions were prepared using the ultrasonic homogenization method, and different concentrations (i.e., 10%, 20%, and 40% w/w) were added to the CSG solutions; these active coatings were used to cover the burgers. CSG-based coatings, especially coatings containing the highest concentration of nanoemulsions (40%), caused a significant decrease in the oil uptake and moisture retention, acrylamide content, and HMF content of fried burgers. The texture of coated burgers was softer than that of uncoated samples; they also had a higher color brightness and a lower browning index. Field emission scanning electron microscopy analysis showed that RCE concentration less than 40% should be used in CSG coatings because it will cause minor cracks, which is an obvious possibility of failure of coating performance. Coating significantly (4-10 times) increased the antioxidant activity of burgers compared to the control. In conclusion, it is suggested to use the active coating produced in this study to improve fried burger quality and modulate acrylamide formation.

Turning food waste into value-added carbon dots for sustainable food packaging application: A review.

Carbon dots (CDs) are a recent addition to the nanocarbon family, encompassing both crystalline and amorphous phases. They have sparked significant research interest due to their unique electrical and optical properties, remarkable biocompatibility, outstanding mechanical characteristics, customizable surface chemistry, and negligible cytotoxicity. Their current applications are mainly limited to flexible photonic and biomedical devices, but they have also garnered attention for their potential use in intelligent packaging. The conversion of food waste into CDs further contributes to the concept of the circular economy. It provides a comprehensive overview of emerging green technologies, energy-saving reactions, and cost-effective starting materials involved in the synthesis of CDs. It also highlights the unique properties of biomass-derived CDs, focusing on their structural performance, cellular toxicity, and functional characteristics. The application of CDs in the food industry, including food packaging, is summarized in a concise manner. This paper sheds light on the current challenges and prospects of utilizing CDs in the packaging industry. It aims to provide researchers with a roadmap to tailor the properties of CDs to suit specific applications in the food industry, particularly in food packaging.

Development and characterization of a novel biodegradable and antioxidant film based on marine seaweed sulfated polysaccharide.

This research aims to produce an antioxidant and biodegradable polysaccharide film by using macroalgae agar and sulfated polysaccharide. Agar and sulfated polysaccharide (fucoidan) were extracted from Gracilaria corticata and Sargassum angustifolium macroalgae. Five treatments were conducted: (A) agar film (1%, W:V), (C) chitosan film (1%, W:V + 1% acetic acid), (AC) agar:chitosan composite (50:50, V:V), (ACF) AC film with fucoidan (0.5%, W:V), and (ACFA) ACF film with citric acid (30% of the dry weight of film) as a cross-linking agent. Then, 0.75% (V:V) of glycerol was added to all films. The physical, mechanical, antioxidant, color variations, microstructure (SEM), and Fourier transform infrared (FT-IR) spectroscopy were investigated. Based on the results, modifying the agar film with chitosan improved the mechanical strength, humidity, and solubility in the AC composite film (p < .05). Further, adding sulfated polysaccharide and citric acid cross-linking agent to the agar-chitosan composite led to a significant decrease in solubility, humidity, and permeability to water vapor in ACFA films (p < .05), indicating strong cross-linking and reduction in film pores based on the SEM pictures and FTIR results. However, the physical and mechanical properties of the agar-based film obtained from Gracilaria algae can be improved by adding chitosan and citric acid cross-linking agent, and the addition of fucoidan obtained from Sargassum algae has improved its antioxidant properties. This biodegradable film can be a good candidate for preserving perishable products.

Application of Poultry Gelatin to Enhance the Physicochemical, Mechanical, and Rheological Properties of Fish Gelatin as Alternative Mammalian Gelatin Films for Food Packaging.

This study aimed to describe the properties of cold water fish gelatin (FG) blended with poultry gelatin (PG) for a production of a sachet containing olive oil. To find a desirable film, the different ratio of FG-PG-based films were characterized in terms of mechanical properties. As the proportion of PG in PG-FG-based increased, the tensile strength and Young's modulus were increased, and the elongation at break and heat seal strength of the films were decreased. The 50-50 film had favorable characteristics to use as a sachet. The amount of acid index and peroxide of the oil stored in the sachets after 14 days showed that there is a significant difference (p < 0.05) between the films. The barrier properties of the films including the water vapor permeability and oxygen permeability of films were increased from 1.21 to 4.95 × 10-11 g m-1 Pa-1 s-1 and 48 to 97 cm3 mµ/m2 d kPa, respectively. Dark, red, yellow, and opaque films were realized with increasing PG. Fourier transform infrared (FTIR) spectra approved a wide peak of approximately 2500 cm-1. The rheological analysis indicated that, by adding PG, viscosity, elastic modulus (G') and loss modulus (G'') were increased significantly (p < 0.05) about 9.5, 9.32 and 18 times, respectively. Therefore, an easy modification of FG with PG will make it suitable for oil sachet packaging applications for the food industry.

The control of fungi and mycotoxins by food active packaging: a review.

Conventionally used petrochemical-based plastics are poorly degradable and cause severe environmental pollution. Alternatively, biopolymers (e.g., polysaccharides, proteins, lipids, and their blends) are biodegradable and environment-friendly, and thus their use in packaging technologies has been on the rise. Spoilage of food by mycotoxigenic fungi poses a severe threat to human and animal health. Hence, because of the adverse effects of synthetic preservatives, active packaging as an effective technique for controlling and decontaminating fungi and related mycotoxins has attracted considerable interest. The current review aims to provide an overview of the prevention of fungi and mycotoxins through active packaging. The impact of different additives on the antifungal and anti-mycotoxigenic functionality of packaging incorporating active films/coatings is also investigated. In addition, active packaging applications to control and decontaminate common fungi and mycotoxins in bakery products, cereal grains, fruits, nuts, and dairy products are also introduced. The results of recent studies have confirmed that biopolymer films and coatings incorporating antimicrobial agents provide great potential for controlling common fungi and mycotoxins and enhancing food quality and safety.

Extraction and characterization of gelatin from the feet of Pekin duck (Anas platyrhynchos domestica) as affected by acid, alkaline, and enzyme pretreatment.

The effects of different pretreatments on yield and composition of extraction, physicochemical, and rheological properties of duck feet gelatin (DFG) were investigated. Gelatins were extracted from the whole feet of Pekin duck with an average yield of 4.09%, 3.65%, and 5.75% for acidic (Ac-DFG), alkaline (Al-DFG), and enzymatic (En-DFG) pretreatment on a wet weight basis, respectively. Proteins at 81.38%, 79.41%, 82.55%, and 87.38% were the major composition for Ac-DFG, Al-DFG, En-DFG, and bovine, respectively. Amino acid analysis showed glycine as the predominant amino acid in Ac-DFG, followed by hydroxyproline, proline, and alanine for Ac-DFG, Al-DFG, and En-DFG, respectively. Rheological analysis indicated that the maximum elastic modulus (9972.25Pa) and loss modulus (4956.28Pa) for Ac-DFG gelatin were significantly higher than those of other gelatins. Extracted gelatins contained α1 and α2 chains as the predominant components, and enzymatic gelatin had low molecular weight peptides. Fourier transform infrared spectroscopy showed that the peak of the gelatins was mainly positioned in the amide band region (amides I, II, and III). A considerable loss of molecular-order triple helical structure was also observed after pepsin treatment. In summary, duck feet gelatin has potential to replace as mammalian gelatin in food and pharmaceutical industry.

Comparison of physicochemical and functional properties of duck feet and bovine gelatins.

BACKGROUND: Previous studies have indicated that duck feet are a rich source of gelatin extractable from avian sources. In this study, the physicochemical and functional properties of avian gelatin extracted from duck feet (DFG) with acetic acid were compared with those of commercial bovine gelatin (BG). RESULTS: The yield of DFG obtained in this study was 7.01 ± 0.31%. High-performance liquid chromatography analysis indicated that the imino acid content was slightly lower for DFG compared with BG (P < 0.05). Differences in molecular size and amino acids between DFG and BG were also observed. The isoelectric points of DFG and BG were at pH 8 and 5 respectively, and the overall protein solubility of BG was higher than that of DFG. Gels prepared from BG exhibited higher bloom strength, viscosity and clarity and were darker in colour compared with DFG gels (P < 0.05). The gelling and melting points of BG were 21.8 and 29.47 °C respectively, while those of DFG were 20.5 and 27.8 °C respectively. BG exhibited slightly better emulsifying and foaming properties compared with DFG. CONCLUSION: Although some differences between DFG and BG were observed, the disparities were small, which indicates that DFG could be exploited commercially as an alternative source of gelatin. © 2016 Society of Chemical Industry.

Preparation and characterization of bionanocomposite films filled with nanorod-rich zinc oxide.

The effects of zinc oxide nanorods (ZnO-nr) incorporation on the physical, mechanical, heat sealability, barrier, thermal and antibacterial properties of sago starch and bovine gelatin bionanocomposites films were investigated. The ZnO was incorporated into the films at different concentrations (1-5%, w/w total solid). All films were plasticized with 40% (w/w of total solid) of a combination of sorbitol/glycerol at 3:1 ratio. Incorporation of 5% of ZnO-nr to starch and gelatin films decreased the permeability to oxygen by 40% and 55%, respectively. Moisture content and water absorption capacity of the films were decreased by increasing the ZnO-nr contents. Mechanical and heat seal properties of the films were increased more than 20%. The films exhibited UV absorption and displayed an excellent antimicrobial activity against the Escherichia coli. These properties suggest that bionanocomposites based on ZnO-nr have the potential as an active packaging material for food and pharmaceutical industries.